Burner Removal And Fitting And Leak Test Procedure - Beef Eater 1600 Series Assembly And Operating Instructions Manual

BURNER REMOVAL, FITTING AND LEAK TEST PROCEDURE
IMPORTANT
After completing the gas hose connections, conduct a leak test following the leak test procedure before using the appliance.
WARNING
To ensure gas tight connections, complete the gas leak test procedure before and after gas hose connection and after every reconnection of the gas
cylinder. Failure to do so may result in a fire or explosion.
Leak test procedure
• Ensure all gas valves are in the 'OFF' position.
• In a small container, mix a solution of water and detergent
or soap.
• After connection of the hose, turn on the gas supply at the
gas bottle.
• Using a brush apply the solution to all gas connection
points and look for bubbles forming.
18
BURNER REMOVAL, FITTING AND LEAK TEST PROCEDURE
• Bubbling will indicate a leak.
• Turn off the gas supply and re-tighten the joint.
Repeat the leak test.
• If the leak persists, turn off the gas at the bottle and contact
a licensed gas fitter to correct.