Binding The Evotouch Controller To The Hce80(R) / Hcc80(R) Underfloor Heating Controller - Honeywell evohome Applications Manual

4.7 Binding the evotouch controller to the HCE80(R) / HCC80(R) underfloor
heating controller
i
For zones 2 – 6 an external room sensor (DT92 / HCW82 / HCF82) must be bound to the evotouch controller.
4.7.1 Binding room sensor
f Follow the guided or expert configuration until the
following screen appears.
f Press and hold the installation button (1) at the
underfloor heating controller for approx. 2 seconds.
The LED of zone 1 flashes red.
f Position the evotouch controller as close as possible
to the underfloor heating controller.
f Press the BIND button on the
to send the bind signal to the underfloor heating
controller.
The LED of the selected one lights continuously red.
Press the BACK button on the
f
proceed with the binding of the room setpoint.
Application Manual
evotouch controller
evotouch controller to
1
2
3
37