Honeywell evohome Applications Manual page 38

4.7.2 Binding room setpoint
f Follow the guided or expert configuration until the
following screen appears.
f Press and hold the installation button (1) at the underfloor
heating controller again for approx. 2 seconds.
The LED of zone 1 (2) flashes green.
evotouch controller as close as possible
f Position the
to the underfloor heating controller.
f Press the BIND button on the
to send the bind signal to the underfloor heating
controller.
The LED of zone 1 (2) lights continuously green.
Binding of further zones
i
In order to assign further zones press the installation button again until the LED of the desired zone flashes red and
then repeat the binding procedure.
38
evotouch controller
1
2
3
evotouch