Table of Contents
Advertisement
1.8.3 Mail Communication Status
(Comm Window 4/5)
The status of mail transfer (including the total number of items,
number of items sent, number of items failed to send, and number
of items not yet sent) is displayed.
Communication status
Mail
(Among the ten items of mail, seven have already been sent, one
could not be sent, and two have yet to be sent because transfer is
currently underway. "Mi 2" indicated instead of "Ye 2" means that
two items have not been sent because transfer was interrupted by
the
there are two items remaining to be sent, and awaiting retry. At the
"Mail" item, press the
remaining-to-be-sent mail.)
1.8.4 Mail Transfer Test
(Comm Window 4/5)
Executing the mail transfer test sends test mail.
If the test mail cannot be sent, check whether the settings you
made are correct.
If more than 100 items of mail yet to be sent have accumulated
(such as when PPP calls cannot be connected), the oldest mail
yet to be sent is assumed to have failed and will not be sent. At
startup, all mail yet to be sent is cleared.
The mail transfer time required when sending mail via PPP at 9600
bps is about 100 bytes * 8 bits/9600 bps = just under one second.
(Moreover, additional time is required before and after sending
mail; about 30 seconds to make a call and about 30 seconds to
disconnect.)
The mail transfer time required when sending mail via LAN is about
100 bytes * 8 bits/10 Mbps = just under one second.
To 10
Fi 7
Mi 1
button. "Wa 2" indicated instead of "Ye 2" means that
/
1.8 Sending Mail
Ye 2
buttons to send the interrupted and
69
1
2
3
4
5
6
7
8
9
10
11
Advertisement
Table of Contents
