52
1.7 Automatic Data Transfer by FTP Client
When the DNS is enabled, use the specified IP address other than
0.0.0.0. If the specified IP address is 0.0.0.0, use the IP address
obtained by referring to the DNS by its server name. At that time,
specify the server name in full domain as "server.xyz.xx.xx." A
server name like "server" cannot be used to refer to the DNS.
Comm Window (PPP 4/5, 1/5)
1.7.3 FTP Communication Status
(Comm Window 4/5)
The status of FTP communication (including the total number of
items, number of items sent, number of items failed to send, and
number of items not yet sent) is displayed.
Communication status
FTP
(Among the ten items of FTP data, seven have already been sent,
one could not be sent, and two have yet to be sent because trans-
fer is currently underway. "St 2" indicated instead of "Ye 2" means
that two items have not been sent because transfer was inter-
rupted by the
means that there are two items remaining to be sent, and awaiting
retry. At the "FTP" item, press the
interrupted and remaining-to-be-sent data.)
To 10
Fi 7
Mi 1
button. "Wa 2" indicated instead of "Ye 2"
Ye 2
/
buttons to send the