Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Risco GT 601
Summary of Contents for Risco GT 601
- Page 1 GT 601 Quick User Guide...
- Page 2 Introduction The GT 601 Control Panel can control up to 136 zones with 99 individual Users. Control of the system is via Remote Keypads (RKPs). Control is also possible via Proximity Reader(s). Facility is provided for Central Station and/or Vo- Comm (message communication) to inform of system status and alarm events.
- Page 3 Present your G-Tag to the Reader The display will show:- Press NO until the Code Type you require is displayed then press YES. Code Group Display will show:- (See full user Instructions for Code Types) = None ok ? Some examples below: Set Only Only Allows for the setting of the system.
- Page 4 Referring to the character map enter the required character (pressing the 3 key will display 'G', pressing it again will show 'H' and again will show 'I '), once the correct character is displayed press YES and the display will move on to the next position. Continue entering characters (up to 9).
- Page 5 Setting the System (Using Master or Main) 01 JAN 18 : 58 : 01 With the display showing:- Enter your User code. EXIT ! 1 The display will show:- All Zones ON and a continuous exit tone will sound. (Also See “Pre-Exit Check” in Main User Instructions) Time will count down Note: Count down in display depends on the setting mode programmed by the Engineer.
- Page 6 Note: If a Global code (Master or Main) has been used, all areas that are being set will be Part 1 set. Note: If an Area Main code has been used only Part 1 set for that associated area will occur. Note: Your installation company will have informed you what zones are being removed (omitted) for the Part Set you are using.
- Page 7 Re-setting the system. <<<< ALARM >>>> If the system is programmed for Any code reset, enter a User code. Press NO to view The display will show:- Note: If NO is NOT pressed then the alarm status will only be displayed for ten seconds. ! ! Enter Code ! ! The display will then show:- Enter your user code again.
- Page 8 © RISCO Group 12/2019. All rights reserved. 5IN1839 B Page 8...
Need help?
Do you have a question about the GT 601 and is the answer not in the manual?
Questions and answers