Brother CS-8072 Operation Manual page 68

4. Set the extra spool pin into the hole on the end of the bobbin
1
1 Extra spool pin for right needle threading.
2 Push the spool pin securely into place.
2
5. Do not set the thread in the needle clamp thread guide on the
5
6
Caution
The needle threader can not be used. Thread the twin nee-
dle by hand, from front to back. Using the needle threader
may result in damage to the machine.
Stitch length
•
•
Types of thread
Cotton thread or spun thread are recommended because syn-
thetic threads may break.
winder shaft on the top of the machine. Follow the instructions
for single-needle threading.
needle bar. Thread the needle on the right side.
CAUTION
Stitch width
Adjust the stitch width. Turn the balance wheel to
check the needle does not touch the needle plate. If
the needle hit the needle plate the needle may break
and cause injury.
Straight 2 mm min.
Others 0.5 mm min.
65