Brother CS-8072 Operation Manual page 18

5
1 1
2
5
5
8. Lower the needle threader lever all the way down using your
left index finger. Check that the thread is held by the guide
(large hook) and that the third hook on the needle threader
has passed through the eye of the needle.
1 Second set of hooks
2 Third hook
9. As you lower the needle threader lever, pull the thread to the
left and catch it on the large hook. When the needle threader
lever is in the lowest position, pull the thread in front of the
needle's eye and catch it on the third hook.
* Rotate your right hand slightly to check that the thread is en-
gaged.
10. While gently holding the thread, raise the needle threader le-
ver.
11. Pull the thread towards the rear to finish the upper threading.
CAUTION
The needle threader lever can only be used with
home sewing machine needles size 75/11-100/16.
Check the table on page 26 for appropriate needle
and thread combinations. Note that, if you are using
transparent nylon
needles in the range of 90/14-100/16 can be used.
12. Pass the thread underneath the presser foot and pull it out
from the rear of the machine by about 50 mm(2").
* You do not need to pull the bobbin thread up before you start
sewing.
Note
Always raise the presser foot before removing the upper thread from
the machine or damage may occur to the tension unit.
CAUTION
The needle threader lever can not be used to thread
the needle when you are using decorative threads or
specialty needles like the twin needle and wing nee-
dle. When using those types of threads or needles,
thread the eye of the needle manually. Make sure
the main power switch is OFF when threading the
needle manually.
mono-filament thread, only
15