RTS Altus Manual

Altus RTS, Orea RTS & Sonesse RTS
Programming
1
Select Channel
If you are using a multi channel remote, select the required channel.
The channel must be selected prior to programming.
2
Identify the correct motor mode
In order to iden-
tify which mode the
motor is in, make
sure that you pay
attention to whether
the product performs
a jiggle when power
is applied.
4
YES - jiggle
This means limits have already been set. Press and
hold simultaneously the Up and Down button.
The product should jiggle.
6
Check the correct direction of rotation
Press and hold the
Down button.
Does the product
extend?
7
Reverse the direction of rotation
To reverse the
direction of the
motor, press and
hold the Stop
Press for
button until the
product jiggles.
All Telis RTS Transmitters, Centralis RTS, Chronis RTS, Smoove.
C
Dry Contact Transmitters and 5 Channel RTS Transmitter (cannot be used to program).
Soliris/Eolis RTS Sensor, Sunis/Eolis 3D RTS Sensor (cannot be used to program).
Switch on the power
to the motor.
Only connect one motor at a time.
After the
jiggle
proceed to
step 10.
5 secs
Continue to step 2...
3
Motor Mode
Did the product perform a jiggle?
5
NO - jiggle
Press and hold simultaneously the Up and Down
button. The product should jiggle.
YES - The product extends while pressing the
down button - Go to step 8
NO - The product retracts while pressing the
down button - Continue to step 7
Press and hold
the Down
button to test
that the motor
direction is
correct.
18
YES - Go to step 4
NO - Go to step 5
After the jiggle
continue to
step 6.
Continue to step 8