Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for RTS Bus Expansion Card
Summary of Contents for RTS Bus Expansion Card
- Page 1 ADDENDUM BUS EXPANSION CARD FOR ADAM INTERCOM SYSTEM ™ 9380-7532-000 Rev C , 8/00...
- Page 2 The sole obligation of Telex during the warranty period is to provide, without charge, parts and labor necessary to remedy covered defects appearing in products returned prepaid to Telex.
-
Page 3: General Description
Breakout Panels in an expanded intercom system. Once all components of the expanded intercom system are properly connected, operation is identical to a single- frame intercom system. BUS EXPANSION CARD ADDENDUM 3 on page 9. in this addendum can be used to label the Sta-... -
Page 4: Installation Notes
Set the total number of ADAM frames using Table 8, page 9. (All of the BX cards will have these switches set the same.) 4 BUS EXPANSION CARD ADDENDUM DIP switch S6-4 on each BX card is a test audio dis- able switch:... - Page 5 This completes the additional procedures required when using Bus Expansion Cards. Intercom port connections for the additional ADAM frames are identical to what is described in the ADAM System Installation Guide. No operating procedures are affected. BUS EXPANSION CARD ADDENDUM 5...
- Page 6 Table 2. Allocation of card slots for an intercom system with two ADAM frames. "BX" = Bus Expansion Card; "MC" = Master Controller Card (check for assembly part number 9030-7514 followed by the proper suffix number -200 as listed in this table); "1-8", "9-16" etc. = port numbers for Audio...
- Page 7 Table 4. Allocation of card slots for an intercom system with four ADAM frames. "BX" = Bus Expansion Card; "MC" = Master Controller Card (check for assembly part number 9030-7514 followed by the proper suffix number [-400 or -450] as listed in this table); ports "1-8", "9-16" etc. = Audio I/O...
- Page 8 Table 6. Allocation of card slots for an intercom system with six ADAM frames. "BX" = Bus Expansion Card; "MC" = Master Controller Card (check for as- sembly part number 9030-7514 followed by the proper suffix number [-600 or -650] as listed in this table); ports "1-8", "9-16" etc. = Audio I/O Cards...
- Page 9 Table 7. Bus Expansion Card DIP switch S6 settings to select the frame number in which the card is used Table 8. Bus Expansion Card DIP switch S6 settings to select the total number of ADAM frames and to enable/disable test audio Table 9.
Need help?
Do you have a question about the Bus Expansion Card and is the answer not in the manual?
Questions and answers