Leckey Squiggles Stander User Manual page 13

Always make sure the locking
pin is fully engaged before you
place the child in the stander.
9.6 ATTACHING THE
SUSPENSION SYSTEM
To attach the suspension system
first attach the base which has the
suspension spring attached. To do this
line up the holes and insert the four bolts
and place the washers and nuts onto the
bolts. Tighten securely ensuring the bolts
protrude through the end of the nut.
Lastly insert the hub assembly into the
top and set to the required height for the
size of wheels you have ordered. For 27"
wheels align the bottom hole
hub with the top hole in the suspension
C , insert the bolt and secure with the
nut on the other side. To setup the
suspension for the 24" wheels align hole
with hole C and secure with the bolt
and nut.
Repeat the process on the opposite side
for the other wheel.
9.7 ATTACHING
THE WHEELS
To attach the wheels to the chassis
the brakes must be off. Lift the chassis
in the
slightly off the ground while pressing the
black button in the centre of the wheel.
Continue holding the black button,
attach the wheel to the chassis then
release the black button. To remove the
wheels reverse this process.
Squiggles Stander - User Manual p13