Table of Contents
Advertisement
Engine speed setting
You can set the idling speed and the working
speed.
To operate auxiliary equipment, e.g. hydraulic
pumps, the engine must be running at a specific
speed (working speed).
X
Stop the vehicle.
X
Apply the parking brake.
X
Shift into neutral.
X
Engage power take-off.
Activating the engine speed setting and set-
ting the engine speed
X
Press the Ù button on the multifunction
steering wheel repeatedly until the
speed
input window is shown in the on-board
computer.
X
Press the s or r button to increase or
decrease the engine speed in increments of
approximately 20 rpm.
X
Press the 9 button to exit the input window.
or
X
Wait for approximately 3 seconds.
The setting is stored automatically.
Deactivating the engine-speed setting
X
Press the Ù button repeatedly until the on-
board computer shows the
input window.
X
Press the u button.
The engine speed setting is automatically reset
if you drive faster than approximately 20 km/h.
Constant engine speed
When the constant engine speed function is
activated, the set working speed for power take-
off is controlled by the electronic management
system, regardless of the load.
i
Engine
X
X
X
X
X
X
Engine speed
Tipper operation
Before tipping
G
The rear exterior lighting is concealed when
the tailgate is opened. This could cause other
Tipper operation
The constant engine speed function is used
to set the working speed governor. In working
speed operation, regeneration is suppressed.
Deactivate the constant engine speed func-
tion after operating power take-off. Other-
wise, regeneration cannot take place.
As well as the constant engine speed other
structurally dependent functions can be acti-
vated in vehicles with power take-off on the
engine.
Stop the vehicle.
Apply the parking brake.
Shift into neutral.
Engage transmission-driven or transmission-
independent power take-off.
To activate: press the upper section of the
F switch.
The indicator lamp in the F switch lights
up.
To deactivate: press the lower section of the
F switch.
The indicator lamp in the F switch goes
out.
WARNING
345
Z
Advertisement
Table of Contents
