Table of Contents
Advertisement
FleetBoard Truck Data Center 6 (DTCO)
198
can be sent to the headquarters using the Fleet-
Board vehicle computer.
X
Switch the ignition lock to the drive position.
i
If the green LED indicator lamp on the Ser-
vice Call button goes out after lighting up at
the start, the FleetBoard vehicle computer is
ready for operation.
X
To send a Service Call message/to acti-
vate roadside assistance: press the Ó
button for approximately 2 seconds.
The LED indicator lamp flashes orange. The
FleetBoard vehicle computer generates the
data to be sent; this takes approximately
3 minutes. Leave the ignition switched on
while the data is being sent. When the Service
message has been successfully sent, the LED
indicator lamp lights up green for approx-
imately 4 seconds. The roadside assistance
data is now available to Mercedes-Benz Ser-
vice.
X
Turn ignition lock to position u.
X
Contact Mercedes-Benz Service (Customer
Assistance Centre or national organisation).
If the LED indicator lamp flashes red for approx-
imately 4 seconds, the service message was not
sent. In this case:
X
Change the vehicle location.
X
Send the Service message again.
Reading out the driver card and send-
ing the data
Driver card (example) (source: FMTA)
The data from the digital tachograph is stored on
the driver card. This data will be automatically
transmitted from the FleetBoard vehicle com-
puter to the FleetBoard Service Centre. Once
the data has been transmitted, the central fleet
office can download the data from the Fleet-
Board Service Centre via the Internet. The data
must be made available to the authorities if
requested.
You can use the driver card for unambiguous
identification of the driver.
Avoid touching the contact surface points of the
memory chip with your fingers. Errors could oth-
erwise occur when reading the memory chip.
LED indicator lamp display
The status of the FleetBoard vehicle computer
can be read out on the LED indicator lamp below
the Service Call button.
i
If the FleetBoard vehicle computer is not
activated, the LED indicator lamp lights up
green and then goes out when the ignition is
switched on.
LED indicator lamp
Flashes green
Lights up green for
approximately
4 seconds and then
goes out
Lights up continu-
ously in red
Free and open source software
Information on licences for the free and open
source software used in your device can be
found on this website:
http://www.fleetboard.com/license
Meaning
The FleetBoard vehi-
cle computer starts
up. The process can
last several minutes.
The FleetBoard vehi-
cle computer is ready
for operation.
The FleetBoard vehi-
cle computer has
detected a fault and
is no longer function-
ing.
X
Turn the ignition off
and then on again.
X
Check the display
in the on-board
computer in the
Diagnosis
menu.
X
If the problem per-
sists: call Fleet-
Board support
Y
(
page 147)
Advertisement
Table of Contents
