Quick Start Guide
PAIRING MICROPHONES TO THE 975
Your system is shipped with microphones and base units pre-paired for quick and easy use.
If you ever need to pair new components, follow this pairing process:
1
POINT MICROPHONES AT TOPCAT
From a powered off state, point the IR
transmitter lens toward the base unit
(for Sharemike, the transmitter lens is
located on the back of the microphone).
POWER
IR TRANSMITTER
MIC 1
MIC 2
2
PRESS AND HOLD POWER BUTTON
Press and hold the power button for
5 seconds until the Mic 1 and Mic 2 lights
start flashing, then release the button
and let the pairing process finish.
3
CONFIRM STATUS
The status light on the 975 will light
up indicating the pairing process is
complete. The Mic 1 or Mic 2 light on
the microphone will stay illuminated.
For complete operating instructions, go to
MIC 1
MIC 2
POWER
BACK
FRONT
SHAREMIKE
www.lightspeed-tek.com/975-usermanual
FLEXMIKE
(or scan the 2D barcode).
Power
Status
Audio
Push
Output
Audio
Audio
Tone
Level
Input
Output
STATUS LIGHT
QS0592US01-4
Need help?
Do you have a question about the 975 and is the answer not in the manual?