Table of Contents
Advertisement
to reach the material being processed.
• When using PTFE-coated magnetic bars, the following hase to
be noted: Chemical reactions of PTFE occur in contact with mol-
ten or solute alkali metals and alkaline earth metals, as well as
with fine powders of metals in groups 2 and 3 of the periodic
system at temperatures above 300 °C - 400 °C. Only elementary
fluorine, chlorotrifluoride and alkali metals attack it; halogenated
hydrocarbons have a reversible swelling effect.
(Source: Römpps Chemie-Lexikon and "Ulmann", Volume 19)
For protection of the equipment
• The appliance may only be opened by experts.
• The voltage stated on the type plate must correspond to the mains
voltage.
• Do not cover the device, even partially e.g. with metallic plates
or film. This results in overheating.
• Ensure that the base plate is kept clean.
• Protect the appliance and accessories from bumps and impacts.
• Only use glass encapsulated temperature sensors for electroly-
sis procedures.
• Observe the minimum distances between the devices, between
the device and the wall and above the assembly (min. 800 mm).
28
Proper use
3
• Use
-
For mixing and/or heating liquids
• Range of use
- Laboratories
- Schools
- Pharmacies
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply network
that also supplies residential areas.
The safety of the user cannot be guaranteed if the appliance is
operated with accessories that are not supplied or recommended
by the manufacturer or if the appliance is operated improperly con-
trary to the correct use and the manufacturer's specifications or if
the appliance is modified by third parties.
4
Unpacking
Please unpack the equipment carefully and check for any dama-
ges. It is important that any damages which may have arisen
during transport are ascertained when unpacking. If applicable a
fact report must be set immediately (post, rail or forwarder).
The delivery scope covers:
an IKAMAG RET control-visc/C, an operating instructions, a main
cable and a short instruction.
092008
Advertisement
Chapters
Table of Contents
