Table of Contents
Advertisement
module captures 64K samples and uploads them to the host over the
serial port.
Set acquisition parameters from the tool bar or the pull-down menus.
See Table 6 for a summary of the parameters.
Acquisition Speed
Trigger Position
Trigger Pattern
Once you set the acquisition parameters, click the Run button (red
triangle) to begin acquisition. The analyzer begins capturing data. After
you acquire the initial 64K samples, sampling continues until Silicon
Figure 6. Analyze Module
Table 6. Acquisition Parameters
10 Khz to 100 MHz asynchronous or
synchronous to 100 MHz
4K Pre Trigger / 60K Post Trigger
32K Pre Trigger / 32K Post Trigger
60K Pre Trigger / 4K Post Trigger
Click on individual signals in the T column to
specify don't care, low, high, rising, falling or
either edge. The trigger pattern is the logical
AND of the 18 patterns.
Using the Analyze Module
13
Advertisement
Table of Contents
