Using The Command Module; Explore The Fpga - Actel Silicon Explorer II Quick Start Manual

Using the Command Module

Explore the
FPGA
The Command module is the interface used to select internal nodes in
the Actel FPGA family. Use the Command module (Figure 3) to
program Actel's ProASIC devices. The following sections describe
exploring with the probe and programming a ProASIC device.
Note: At this time only FPGA devices have probe capability.
The following procedures describe how to use the Command module
to examine an Actel FPGA.
To open a probe file:
1. Launch Silicon Explorer. Select Silicon Explorer from the
Designer menu under Programs in the Start menu.
Figure 3. Command Module
Using the Command Module
9