JLG TOUCAN 12E Operation And Safety Manual page 57

2. Emergency Stop Switch - A two-position, red, emer-
gency stop switch, when positioned to ON furnishes
operating power to the platform control station. In
addition, the switch can be used to turn off power to
the function controls in the event of an emergency.
Power is turned off by depressing the switch and
power is turned on by turning the switch clockwise to
pull it out.
3. Trigger Switch - This switch located at the front of the
controller acts as an enable and must be depressed
before operating the drive, steer and swinging func-
tions. When released, the function being operated will
stop.
4. Drive/Swing Functions Controller - This dual axis
joystick controls drive and swinging functions. The
speed of both functions is proportionally controlled
by the distance of travel of the hand joystick.
Drive - Engage the trigger switch lever (3) with the
joystick in neutral position then move the control han-
dle forward to drive the machine forward or move the
control handle backward to drive the machine back-
ward.
Swing - Engage the trigger switch lever (3) with the
joystick in neutral position then toggle the control
31210313
SECTION 3 – MACHINE CONTROLS, INDICATORS AND OPERATION
– JLG Lift –
handle to the left to swing the superstructure to the
left or toggle the control handle to the right to swing
to the right.
5. Steer Switch - The thumb-operated steer switch on
top of the control handle activates the steer wheels in
the direction activated (right or left).
6. Function Enable Button - This button is used to
enable mast, boom, telescope, platform levelling and
rotation (if equipped) functions. It must be depressed
and held before actuating a boom, telescope, platform
levelling or rotation (if equipped) function. When
released, the function being operated will stop.
7. Mast Lift Up/Down Joystick Controller - This finger-
tip, single axis, joystick controller operates Mast Lift Up
and Lift Down functions.
With the joystick controller in neutral position, push-in
and hold the Function Enable Button (6), moving the
joystick Up will raise the mast and moving the joystick
Down will lower the mast. The speed of the move-
ments is proportionally controlled by the distance of
travel of the joystick.
3-19