Remote Retrieval; Using Remote Retrieval Access Code - Brother MFC-9200C User Manual

Remote Retrieval

You can call your MFC from any fax machine using touch tone, then use the
Remote Retrieval Access Code and other button presses to retrieve fax
messages. Cut out the Remote Retrieval Access Card on the last page of this
manual and keep it in your wallet as an aid.

Using Remote Retrieval Access Code

1
Dial your fax number from a fax machine using touch tone.
2
When your MFC answers, immediately enter your Remote Retrieval Access
Code (1 5 9
3
The MFC signals the kinds of messages received:
1 long beep — Fax message(s)
No long beeps — No messages
4
The MFC then prompts you with two short beeps to enter a command. If you
wait longer than 30 seconds to enter a command, the MFC will hang up. If you
enter an invalid command, the MFC will beep three times.
5
Press 9 0 to reset the MFC when you're finished.
6
Hang up.
If your MFC is set to Manual mode, you can access it by waiting about 2
Note
minutes, then entering the Remote Retrieval Access Code within 30 seconds.
8 - 3
R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X )
).