Table of Contents
Advertisement
If You Are Having Difficulty with Your MFC
If you think there is a problem with your MFC, make a copy first. If the copy
looks good, the problem is probably not your MFC. Check the chart below and
follow the troubleshooting tips.
DIFFICULTY
Printing or Receiving Faxes
Condensed Print and Horizontal
Streaks / Top and Bottom of
Sentences Are Cut Off
Poor Quality Print
Smudged stain on the top center of the
printed page
Printing Too Dark or Too Light
Printing Appears Dirty or Ink Seems
to Run
White Lines in Text or Graphics
Stains Appear on the Reverse Side or
at the Bottom of the Page
Vertical Black Lines When Receiving
Received color fax prints only in B &
W.
Replace the color ink cartridges that
are empty or nearly empty. (See
Replacing the Ink Cartridges
page 23-16.)
Phone Line or Connections
MFC Does Not Answer When Called
Sending Faxes
Poor Transmitting Quality
Transmission Verification Report
says "Result:NG"
Vertical Black Lines When Sending
23 - 6
T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
If your copy looks good, you probably had a bad connection, with static or
interference on the phone line. If the copy looks bad, call Brother Customer
Service at 1-800-284-4329 (USA), 1-800-853-6660 (from within
Canada) or 1-514-685-6464 (from within Montreal).
Make sure the Printer Driver matches the type of paper you are using (see
15-6). If you are using plain paper, try using recommended special paper
(see Chapter 2). Don't handle the paper until the ink is dry. Adjust the
Vertical Alignment (see page 23-10).
Press the purple paper thickness adjustment lever down. (See
for Thick Paper and Envelopes
Make sure your ink cartridges are fresh. Cartridges are good up to two
years, after that the ink may become clogged. Cartridge expiration dates are
printed on the package. Make sure the Printer Driver matches the type of
paper you are using (see page 15-6.). Try using recommended special paper
(see Chapter 2). The recommended environment for your MFC is between
50°F to 95°F.
Make sure you are using the recommended paper (see Chapter 2). Don't
handle the paper until the ink is dry.
The recommended environment for your MFC is between 50°F to 95°F.
Clean the print head (see Cleaning the Print Head, page 23-9).
Make sure the Printer Platen and Pick Up Roller are not dirty with ink mist.
(See page 23-15).
The sender's scanner may be dirty. Ask the sender to make a copy to see if
the problem is with the sending machine. Try receiving from another fax
machine.
If the problem continues, call Brother Customer Service at 1-800-284-4329
(USA), 1-800-853-6660 (from within Canada) or 1-514-685-6464 (from
,
within Montreal).
Make sure the MFC is not in MANUAL mode. Check for dial tone. If
possible, call your MFC to hear it answer. If there is still no answer, check
the telephone line cord connection. If there is no ringing when you call your
MFC, call your Telephone Company to check the line.
Try changing your resolution to FINE or SUPERFINE. Make a copy to
verify your MFC's scanner operation.
There is probably temporary noise or static on the line. Try sending the fax
again. If the problem continues, call the Telephone Company to check your
phone line.
If the copy you made shows the same problem, your scanner is dirty (see
Cleaning the Scanner, page 23-14).
SUGGESTIONS
, page 14-2.)
Adjusting
Advertisement
Table of Contents
