Settings; List Of Parameters; Setting The Parameters; Selecting The Operating Mode - Baxi SPC SPLIT Installation And Service Manual

9 Settings

9 Settings
9.1

List of parameters

Tab.19 Operating modes
Digit
Tab.20 Adjustable parameters
Parameter
9.2

Setting the parameters

Digit Operating Description
mode
Automatic Domestic hot water is heated according to the cli­
mode mate conditions:
by the heat pump, and/or
by the immersion heater.
Hybrid mode Domestic hot water is:
first pre-heated using the heat pump,
then heated by the instant boiler.
Optimisation Domestic hot water is heated for pre-determined
Mode periods:
by the timer programming,
by the off-peak rate signal.
Domestic hot water is heated by the heat pump
and by the immersion heater to reach the set point
temperature before the end of the off-peak rate.
Consumption Read the different consumption values
mode
Cooling The refrigerant can be recovered.
mode
62 SPC Split
Associated Mode
AUTO MODE = AUTOMATIC MODE
HYBRID MODE = HYBRID MODE
OPT.BACKUP = PEAK RATE/OFF-PEAK RATE OPTIMISATION MODE
RESET METERS
COOLING MODE
Description
Hysteresis for starting heating.
Can be set from 3 to 20°C.
Room temperature limit authorised for operation of the heat
pump, in Hybrid Mode.
Can be set from -14 to 20°C.
Room temperature operating limit for the electrical back-up.
Can be set from -5 to 18°C
Main timer range duration at Off-peak rate if wired, in Optimi­
sation Mode.
9.2.1
1. Access the list of available operating modes by simultaneously
pressing the
2. Select the desired mode by pressing the
3. Confirm the selection by pressing the

Selecting the operating mode

and keys.
Adjustment required
/
THmin setting: heat pump minimum operating tem­
perature.
H1 setting: duration (in hours) of the longest off-
peak time range.
Factory setting
5°C
5°C
3°C
8 hours
or key.
key.
7740321 - v04 - 03122019