Saneo 9000 BTU AC016D Manual page 46

The room is not
cool enough.
The air
conditioner emits
an unpleasant
noise.
The compressor
does not work.
The remote
control does not
work.
E1 code is
displayed.
E2 code is
displayed.
The illustrations are non-contractual.
SELECTIVE COLLECTION OF ELECTRICAL AND ELECTRONIC WASTE
Electrical products should not be disposed of with household products. According to the
European Directive 2012/19/EU for the disposal of electrical and electronic equipment and
its implementation in national law, used electrical products must be collected separately
and disposed of at the collection points provided for this purpose. Contact your local
authorities or dealer for recycling advice.
WARRANTY TERMS AND CONDITIONS
This product is guaranteed for a fixed period of time with the distributor from the date of
purchase against any failure resulting from a manufacturing or material defect. This
warranty does not cover defects or damage resulting from improper installation, improper
use or abnormal wear and tear of the product.
The device must be returned in its original packaging and accompanied by the receipt,
subject to proper handling. Therefore, observe the operating instructions and safety
instructions given above. In addition, we cannot guarantee your device if you or a third
party has made any modifications or repairs.
In dehumidifying
temperature is too low.
The room is in direct sunlight.
The doors and windows are open or
there are heat sources in the room.
The filter is dirty.
The air inlets and outlets are clogged.
The air conditioner is not on a flat
surface.
The air conditioner is in safety mode to
prevent overheating.
The remote control is too far away from
the air conditioner.
The remote control is not aligned with
the remote sensor on the appliance.
The batteries do not work.
The pipe temperature
abnormal.
The room temperature
abnormal.
mode, the The appliance should be placed in a room with
a temperature of more than 17°C.
Close the curtains.
Close the doors and windows and remove the
heat sources.
Clean or replace the filter.
Unclog the air inlets and outlets.
Place the air conditioner on a flat and stable
surface to reduce the unpleasant noise.
Wait for the temperature to lower for 3
minutes, then restart the appliance.
Bring the remote control closer to the air
conditioner and align the remote with the
sensor.
Replace the batteries.
sensor is Check the pipe temperature sensor and
associated circuits.
sensor is Check the room temperature sensor and the
corresponding circuits.