Saneo 9000 BTU AC016D Manual page 44

Installation of the window kit
- Open the window halfway and install the window kit as shown in the diagrams below. The kit
can be installed horizontally or vertically.
- The flat end of the drain pipe connections must be clipped into place.
- Do not twist or block the drain pipe.
- The length of the drain pipe is 280mm at most and can extend to 1500mm. Do not use
extension cords or other replacement hoses as this may cause malfunction. The drain pipe must
not be blocked, otherwise it may cause overheating.
Water drainage
1) When the air conditioner stops when the tank is full, turn it off and disconnect the plug.
Caution - Please move the unit carefully so as not to spill the water into the water tray at the
bottom of the unit.
2) Place a container under the side water outlet behind the air conditioner.
3) Unscrew the drain cover and remove the water plug, the water will automatically flow into the
container.
MAINTENANCE
1. Before cleaning, unplug the unit.
2. Do not use chemicals to clean the unit.
3. Never clean the unit directly under water or any other liquid.