Brother MFC-7840W Quick Setup Manual page 26

STEP 2
Installing the Driver & Software
9
Choose the appropriate key number and
press OK.
Set WEP KEY
KEY1:
Enter the WEP key you wrote down in step 1
using the dial pad. You can use the
to move the cursor. For example, to enter
the letter a, press the 2 key on the dial pad
once. To enter the number 3, press the 3 key
on the dial pad seven times.
The letters appear in this order: lower case,
upper case and numbers.
Press OK when you have entered all the
characters, then press 1 to apply your settings.
Go to step 12.
Most access points and routers can store
more than one key, but they will only use
one at any time for authentication and
encryption.
10
Press the
Encryption Type and press OK.
Enter the WPA-PSK Password you wrote down
in step 1 using the dial pad. You can use the
or
example, to enter the letter a, press the 2 key
on the dial pad once. To enter the number 3,
press the 3 key on your dial pad seven times.
Press OK when you have entered all the
characters, then press 1 to apply your settings.
Go to step 12.
11
Enter the user name and press OK. You can
use the
example, to enter the letter a, press the 2 key
on the dial pad once.
Enter the password and press OK, and then
press 1 to apply your settings. Go to step 12.
(Use the chart on Entering text on page 46.)
24
or to choose TKIP or AES for
to move the cursor. For
or to move the cursor. For
12
Your machine will now try to connect to your
wireless network using the information you
have entered. If successful, Connected will
appear briefly on the LCD.
Connection NG is displayed when the print
server has not successfully connected to your
router or access point. Try starting from step 3
or
again. If the same message is displayed again,
reset the print server back to the default factory
settings and try again. (See Restoring the
network settings to factory default on page 45.)
13
The machine will automatically acquire the
correct TCP/IP address information from your
access point (router) if DHCP is enabled
(DHCP is normally enabled as default for most
access point routers).
If your access point does not have DHCP
enabled you will need to manually configure
the IP address, subnet mask and gateway of
the machine to suit your network. See the
Network User's Guide for details.
Wireless setup is now complete. To install
the MFL-Pro suite, continue to step 7on
page 26.
Note
The supplied CD-ROM includes the ScanSoft™
PaperPort™ 11SE. This software supports
®
Windows 2000 (SP4 or greater), XP (SP2 or
greater), XP Professional x64 Edition and
Windows Vista
®
Windows Service Pack before installing MFL-
Pro Suite.
Windows
®
only. Please update to the latest
®