XENIA User Manual page 41

Advanced Use Cases
Adapting tray force
The drip tray cover always has some resistance when pushed in or out.
This is intentional so that unnecessary rattling is avoided.
You can influence the amount of resistance with a clamp with about a
span of 30 cm.
1. Attach the clamp to the front edge of the chassis. Then tighten the
clamp, but pay attention not to deform the chassis too much (3-4 mm
should be enough.
2. Repeat the same at the rear of the chassis. Be careful not to get too
close to the panel, and make sure that the span does not pop out
when you turn it because it may go up. A deformation of 2-3 mm is
enough.
3. This procedure should also be applied to the opposite sides on both
the frontside and backside.