Seat Adjustment; Armrest Adjustment; 12-Volt Power Outlet; Hydraulic System - Simplicity Legacy XL Operator's Manual

3. Pull on the seat belt latch to make sure that the belt is
fastened.
4. Tighten the seat belt across the hips.
Release Seat Belt
Press the red button on buckle to release seat belt. The seat
belt automatically retracts.

Seat Adjustment

The seat can be adjusted forward and back.
1. Move the seat adjustment lever (A, Figure 11) and
position the seat as desired.
2. Release the lever to lock the seat into position.
11

Armrest Adjustment

The height of the armrest (A, Figure 12) can be adjusted to
the operator's preference.
1. To increase height, turn the bolt (B) counterclockwise.
2. To decrease height, turn the bolt (B) clockwise.
16
12
The armrest width can be adjusted to the operator's
preference.
1. Loosen the four bolts (C) located behind the seat.
2. Move the armrest away from the seat to a desired
position.
3. Tighten the bolts to lock armrests in position.

12-Volt Power Outlet

Use the 12-volt accessory plug to power small electronic
devices. The accessory must be rated at 9 amps or less. See
Features and Controls.
NOTICE
The 12-volt accessory can cause battery discharge,
especially when the engine is at idle. When the accessory
plug is not used, it must be covered with a rubber plug.
Entrance of water into plug can cause a short circuit.

Hydraulic System

The inboard and auxiliary hydraulics are controlled by
the attachment lift control lever, which raises and lowers
attachments that are connected to the tractor's hydraulic
lift cylinder. This lever also controls attachments connected
to the auxiliary hydraulics through the quick couplers on
the front left and right sides of the frame. The lever has five
positions: left, right, back, forward (first detent) and float
(pushed forward to second detent).
Inboard Hydraulics
The inboard hydraulics control the mower deck and 3-Point
Hitch (if equipped).
1. Make sure the front / rear hydraulic selector switch is in
the REAR position.
2. Pull the attachment lift control lever back (A, Figure 13) to
raise the attachment.
3. Push the attachment lift control lever forward (B) to the
first detent to lower the attachment.
4. Push the attachment lift control lever forward to the
second detent to lock the control in the "float" position.
This lets the lift mechanism to float up and down.