Quick Start Guide
10.2
Environment
10.2.1 Vibration resistance
•
2 g at 10-180 Hz according to IEC 61298-3, level "field with general
application"
•
IACS UR E10 test 7
For compliance with these standards, the transmitter housing must be fully
engaged into the sensor module. This is achieved by rotating the transmitter
housing clockwise to thread limit.
10.2.2 Electromagnetic compatibility (EMC)
•
EMC Directive (2014/30/EU): EN 61326-1
•
EN 61326-2-3
•
NAMUR recommendations NE21
Tests are performed with the recommended electrical wiring using a third
wire interconnecting the COM terminals of the RS-485 network, termination
at each end, and good protective earth.
10.2.3 Built-in lightning protection
EN 61326, IEC 61000-4-5, level 6kV
10.2.4 Radio approvals
•
Radio Equipment Directive (2014/53/EU): ETSI EN 302 372, ETSI EN 302
729 and EN 62479
•
Part 15 of the FCC Rules
•
Industry Canada RSS 211
In challenging applications where the dynamic of the transmitter sensitivity is
(5)
utilized by multiple factors such as small aperture antenna, very low product
dielectric constant and/or turbulent surface, the margin for additional influence due
to extreme EMC may be limited.
24
(5)
Rosemount 5408 Level Transmitter
February 2020