Storage; Spare Module Storage - ABB MNS R Installation Manual

Approximate value for acceptable weights lifted by the cable
Cable diameter
mm
8
10
12
14
16
18
20
24
30
36
For a 90° angle, the acceptable load is approximately 40% greater than the values shown in the table.
The sending units, with one or two compartments, are equipped with single eyebolts.
3.3.3

Storage

Storage kind and time depend on the packaging-type.
Standard packaging:
• After the arrival, the goods must be stored in rooms where no condensation can occur.
• Unpack immediately.
• Let the door opened for several hours, to acclimatize the equipment.
• Cover the panels with plastic sheeting in case of any further storage.
• Check for condensation before the installation.
Packaging for marine transportation/export (on request):
• Protection against moisture is only guaranteed if the packaging is undamaged.
• Intermediate outdoor storage is possible.
• 12-month storage is possible, if the goods is wrapped in heat sealed protective sheeting and the
packaging is undamaged.
• If the storage period is exceeded, the drying agent must be renewed and the plastic covering must
be sealed again.
3.3.4

Spare Module Storage

• In dry rooms.
• Modules must be stored in undamaged original packaging.
• Modules must not suffer sudden changes in temperature.
• Boxes must be stored with the upper side upward.
12
1TTS900001M0902
Acceptable load for a 4-cable device, angle between the cable and the crane
hook
Hemp cable
DlN 83325
Kg
-
180
280
350
470
580
720
1000
1600
2400
Perlon cable
DlN 83330
Kg
-
400
600
820
1060
1340
1660
2400
-
-
Steel cable
DlN 15060 (160 kg/mm )
2
Kg
890
1440
2100
2900
-
-
-
-
-
-