OptConnect ema:Play User Manual page 69

Figure 50
7. Navigate back to the "Operations" page and observe the real time ema:Play "Light" column for
the device in question as shown in Figure 51.
8.
Figure 51
9. According to the logic of the IoT Campaign Intruder – Flash Light Detected, when this value
goes above 1000, the LED 1 (ref des D18) should begin to flash at a frequency of ~2 Hz. Use a
light source and shine it at the light detector (Q2) on ema:Play, while observing the "Light"
column on the "Operations" page for the appropriate device. Confirm that within 10 seconds of
the value crossing the threshold (1000), LED 1 begins to Flash. Reference Figures 51 & 52.
Figure 51
10. The alarm has been triggered. It turns out it was a false alarm, so now it's time to disable the
alarm. Use the second IoT Campaign Disarm System to disable the alarm and stop LED 1 from
flashing. According to the logic of this IoT Campaign, press SW 1 (ref des SW7) on ema:Play to
stop the LED from flashing. Allow 10 seconds for the LED to stop flashing.
© OptConnect Management, LLC 2020. All rights reserved. Revision 1.0
Figure 52
69