Table of Contents
Advertisement
Figure 6
5. Investigate the Atmel | Start Setup: On the right side of the screen, navigate to the "Solution
Explorer", and click on the "Reconfigure Atmel Start Project" button as shown in Figure 7.
Figure 7
This will load the Atmel | Start tool setup relative to this project. This tool can be used to quickly
configure the drivers and middleware for the onboard MCU (U16). For this project, the following
peripherals have already been configured. Reference Figure 8.
ADC_0
EMAPLAY_DEBUG_UART
I2C_0
EMA_MGMT_UART
EMA_MODEM_UART
© OptConnect Management, LLC 2020. All rights reserved. Revision 1.0
Analog to digital converter driver used to convert voltages.
UART communications between U16 and the S2USB enhanced
COMM port (J10), used for console debug I/O.
i2c communications between U16 and the onboard
temperature/humidity sensor (U1).
UART communications between U16 and emaLink.
UART communications between U16 and the ema Modem UART.
22
Advertisement
Table of Contents
