OptConnect ema:Play User Manual page 23

TIMER_0
Figure 8
The "Add software component" button can be used to add various drivers and middleware as
needed.
6. Investigate the PINMUX Configurator in Atmel | Start: On the left side of the screen, click on
the button labeled "Go to PINMUX Configurator" as shown in Figure 9.
Figure 9
This will pull up the PINMUX Configurator where the ema:Play user can change the pin settings
on U16. Note that the column labeled "User Label" is the reference that can be seen in the API
calls from the source code. See Figure 10. Atmel | Start API documentation can be found here:
http://ww1.microchip.com/downloads/en/DeviceDoc/50002633A.pdf .
Timer driver used to create a periodic time-based interrupt for
U16.
© OptConnect Management, LLC 2020. All rights reserved. Revision 1.0 23