Advertisement
2. Install the Media and reassemble the Supply Holder.
If you turn the Removable Supply Holder side down after loading the media, the media may drop by
weight. You might be injured by the dropped media.
Prenez garde à ne pas tenir le support de media avec la flasque amovible vers le bas car le rouleau
de media peut tomber sous l'effet de son proper poids. Dans ce cas, prenez garde à ne pas vous
blesser lors de la chute.
When installing the media roll, do not push on the Non-removable Supply Holder as this will result in
the media roll not being properly centred.
En installant le rouleau de media, ne poussez pas sur la flasque non amovible, car cela aura pour
résultat d'avoir un mauvais centrage du rouleau.
NOTES:
1. This Supply Holder accepts four sizes of media core: 38 mm, 40 mm, 42 mm and
76.2 mm. When using a media roll of 38 mm, 40 mm, or 42 mm, remove the
spacers from the Supply Holders by pushing both hooks of the Spacer. Keep the
removed Spacers safe.
2. Use only inside wound label stock. Outside wound label stock may not feed
properly. Use outside wound label stock at your own risk.
3. Do not over-tighten the green Supply Holder Locking Knob.
1) Place the media roll onto the Supply Shaft with the media feeding from the bottom as shown in the
diagram above.
2) Align the tab of the Removable Supply Holder with the Slot in the Supply Shaft, then reinstall the
Removable Supply Holder by sliding it onto the Supply Shaft as shown in the figure above.
3) Holding the reassembled Supply Holder Unit in your right hand, apply pressure only to the reinstalled
Removable Supply Holder to push it in the direction of arrow
center the media on the Supply Shaft.
4) Tighten the green Supply Holder Locking Knob for the Removable Supply Holder by turning it in the
direction of arrow
5) Tighten the green Supply Holder Locking Knob for the Non-removable Supply Holder by turning it in the
direction of arrow
AVERTISSEMENT!
.
.
WARNING!
CAUTION!
ATTENTION!
, causing the auto centering mechanism to
3
Advertisement
