Hardware Interface; Front Panel - Shure Digital IntelliMix SCM820 Manual

Upgrading to Dante
You can add digital networking capabilities to a standard SCM820 using the Dante Network Interface Card (A820-NIC-DAN).
The card replaces the standard Ethernet port with 2 Dante network ports. This upgrade should only be installed by qualified
service personnel.
Update the firmware on the SCM820 before installing the Dante Network Interface Card. Visit

Hardware Interface

Front Panel

① Channel Mode Selection
Press the button to select the function of the channel knobs and monitor LED rings. See the Audio Signal Adjustment sec-
tion for details on each mode.
② Assignable Channel Knob
Adjusts settings and status for each input:
Rotate: Adjusts a setting.
Momentary Press: Solos the channel to the headphone output.
Press and Hold: Mutes the audio or bypasses the EQ setting.
③ Monitor LED Ring
13 LED segments display gain setting, input signal meter, IntelliMix gain meter, channel solo, or EQ setting.
④ Channel Status LED
LED
Off
Green
Amber
Flicker Red
Solid Red
⑤ Auxiliary Input Jack (1/8")
Channel Status
Channel is closed (attenuated in the automix).
Channel is open (selected in the automix).
Channel EQ is bypassed.
Signal is clipping. Set the channel to a lower input gain level.
Channel is muted.
Shure Incorporated
www.shure.com for more details.
6/59