Philio PST07 Manual page 2

Notice: Use this procedure only in the event
that the primary controller is lost or
otherwise inoperable.
1. Pressing button four times and keep about 5
seconds.
Reset
2. IDs are excluded and all settings will reset to
factory default.
1. Product has a DSK string, you can key in first five
digit to increment smart start process, or you can
scan QR code.
2. SmartStart enabled products can be added into a Z-
Wave network by scanning the Z-Wave QR Code
present on the product with a controller providing
SmartStart
SmartStart inclusion. No further action is required
and the SmartStart product will be added automati-
cally within 10 minutes of being switched on in the
network vicinity.
*notice1:The QR code can be found on the device
or in the box.
3. Have Z-Wave
mode.
4. Pressing tamper key three times within 1.5 seconds
to enter the association mode.
Note: The device support 2 groups. The group 1 is for
Association
receiving the report message, like triggered event,
temperature, illumination etc. The group 2 is for light
control, the device will send the "Basic Set" command
to this group. A group one support 1 nodes maximum
and group two support 5 nodes maximum.
Failed or success in add/remove the node ID can be viewed
•
from Z-Wave TM Controller.
TM Controller entered association
Notice 1: Always RESET a Z-Wave
Z-Wave TM network
Z-Wave TM Notification
After the device adding to the network, it will wake-up once per day in
default. When it wake-up it will broadcast the "Wake Up Notification"
message to the network, and wake-up 10 seconds for receive the
setting commands.
The wake-up interval minimum setting is 30 minutes, and maximum
setting is 120 hours. And the interval step is 30 minutes.
If the user want to wake-up the device immediately, please remove the
front cover, and press the tamper key once. The device will wake-up 10
seconds.
Z-Wave TM Message Report
When the PIR motion triggered, the device will report the trigger event
and also report temperature and illumination level.
* Motion Report:
When the PIR motion detected, the device will unsolicited to send the
report to the nodes in the group 1.
Notification Report (V8)
Notification Type: Home Security (0x07)
Event: Motion Detection, Unknown Location (0x08)
* Tamper Report:
The tamper keys are pressed over 5 seconds. The device will into the
alarm state. In that state, if any one of the tamper keys be released,
the device will unsolicited to send the report to the nodes in the group
1.
2
TM device before trying to add it to a