Table of Contents
Advertisement
NO
Name
Def.
Valid
.
Basic Set
1
99
0 ~ 99
Level
3
PIR
80
0 ~ 99
Sensitivity
1
All
1
0
4 Operation
0
Mode
0
0
0
0
0
3
All
Customer
5
Function
1
Description
Setting the BASIC command value to turn
on the light. The 0x63 means turn on
the light. For dimmer equipment 1 to 99
means the light strength.
0 means turn off the light.
PIR sensitivity settings.
0 means disable the PIR motion.
1 means the lowest sensitivity,
99 means the highest sensitivity.
High sensitivity means can detected long
distance, but if there is more noise signal
in the environment, it will re-trigger too
frequency.
Operation mode. Using bit to control.
Bit0: Setting the temperature scale. (1:
Fahrenheit, 0:Celsius)
Bit1: Reserve.
Bit2: Reserve.
Bit3: Reserve.
3
Bit4: Reserve.
Bit5: Reserve.
Bit6: Reserve.
Bit7: Reserve.
Customer function switch, using bit
control.
Bit0: Tamper On/Off (1:On, 0:Off)
NO
Name
Def.
.
1
0
0
0
0
0
0
PIR Re-
Detect
6
6
Interval Time
Turn Off
7
7
Light Time
Auto Report
8
12
6
Description
Valid
Bit1: Red LED On/Off (1:On, 0:Off)
Bit2: Motion Off.(1:On, 0:Off)
Note: Depends on the Bit2,
1: Report Notification CC,
Type: 0x07, Event: 0xFE
Bit3: Reserve.
Bit4: Reserve.
Bit5: Reserve.
Bit6: Reserve.
Bit7: Reserve.
In the normal mode, after the PIR motion
detected, setting the re-detect time. 10
seconds per tick, default tick is 6 (60
seconds).
Setting the suitable value to prevent
1 ~ 60
received the trigger signal too frequently.
Also can save the battery energy.
Notice: If this value bigger than the
configuration setting NO. 7 There is a
period after the light turned off and the
PIR not start detecting.
After turn on the lighting, setting the
delay time to turn off the lighting when
the PIR motion is not detected. 10
1 ~ 60
seconds per tick, default tick is 7 (70
seconds).
0 means never send turn off light
command.
0 ~ 127 The interval time for auto report the
Advertisement
Table of Contents
