■
6.9 Reference function
● Measurement using the reference function is explained. This product can store one set of measurement conditions or measurement values; i.e.
a waveform which has been measured under the other measurement condition can be displayed at the same time, allowing waveform
comparison. It is called Reference function. Hereinafter, a stored measurement result is called Reference (Ref.) and the latest measurement
result not stored is called Current.
① When a measurement result is displayed, press
② Next, change the measurement condition and make another measurement. The measurement result is Current.
➂ To display Reference, press
Reference waveform is displayed in light blue and Current waveform in yellow. The status is indicated in Select on the measurement
screen (see Fig.6-14 and Fig.6-15).
[Explanatory note] ● : display -: not display
Operation
①
Press once based on ①
Press twice based on ①
Press 3 times based on ①
Press 4 times based on ①
Reference
. Each time it is pressed, the measurement condition and value change as shown in Table 6-7.
Table 6-7 Function of SELECT key
Display graph
Current
Ref.
●
-
-
●
●
●
●
●
Same as ①
Repeated same as above
Select
Current
Fig.6-14 Reference function in B-H graph
to make it Reference.
Cursor measure
Current
Ref.
Current
●
-
-
●
●
-
-
●
Same as ①
44
B-H ANALYZER SY-8218 / SY-8219
Meas. condition
Meas. value
Ref.
Current
●
-
●
-
●
-
●
-
●
-
●
-
Same as ①
Same as ①
Ref.
-
●
-
●