Nokia IP560 Installation Manual page 141

Caution
Protect your appliance or gateway and other electronic equipment
from electrostatic discharge damage by making sure you are
properly grounded before you touch any component.
To replace a power supply
1. Use Nokia Network Voyager or command-line interface (CLI) to perform
2. Locate the power supply on the back of the appliance or gateway and the
Grounding
lug posts
3. Turn off the power to the power supply.
4. Remove the power cord.
5. Loosen the two retaining screws.
6. Remove the grounding cable if one is in use.
IP560 Security Platform Installation Guide
an orderly shutdown of the IP560 appliance.
For information about how to access Network Voyager, see
Network Voyager to Manage Your Security Platform
two retaining screws that secure it
Retaining screws
Replacing a Power Supply
Using Nokia
on page 52.
00353
141