Install- Frequency Table - ADRF SDR User Manual


Center Frequency:
Once a center frequncy is specified and a bandwidth is selected, the system will split the bandwidth value in half
and then add this to the center frequency to obtain your end frequency and also subtract this value to obtain your
start frequency.

Stop Frequency:
If a stop frequency is specified, then this will be the ending frequency of the band selection. Subtracting the
bandwidth value that is selected from the Bandwidth column will give you the start frequency of your band selection.

5.4.4.2 Install- Frequency Table

By clicking on the Frequency Table button, the following screen will appear. You can use the frequency table as
a reference to set the desired bands. Clicking on the Back button will take you back to the previous page.
Advanced RF Technologies, Inc.
Figure 75 Install- Frequency Setting
Figure 76 Install- Frequency Table
58