Install- Brs; Install- Brs Band Selection - ADRF SDR User Manual

5.4.4 Install- BRS

The BRS Install page allows the user to specify the desired frequncies by inputting the Reference Frequency and
Bandwidth. The BRS module supports 1 contiguous bands. Bandwidth selection ranges from 2.5 to 30 MHz. The
Web-GUI requires you to select the exact pass-bands that you will be using and exclude the guard bands when
making your band selections.

5.4.4.1 Install- BRS Band Selection

To specify a frequency, input a DL reference frequency and select either start, center, or stop from the dropdown
menu. Select the desired bandwidth from the dropdown menu under the Bandwidth column and then click Set.

Start Frequency
If a start frequency is specifed, then this will be the beginning frequency of the band selection. Adding the
bandwidth value that is selected from the Bandwidth column will give you the end frequency of your band selection.
Advanced RF Technologies, Inc.
Figure 73 Install - BRS
Figure 74 Install- BRS Band Selection
57