Maintenance And Repair; General Notes On Maintenance - Siemens FLENDER K1N Assembly And Operating Instructions Manual

10.

Maintenance and repair

Observe the instructions in section 3, "Safety instructions", and in section 9, "Faults, causes and remedy"!
10.1

General notes on maintenance

All maintenance and repair work must be done with care and by duly trained and qualified personnel only.
The following applies to all work in item 10.2:
Switch the gear unit and add­on components off.
Secure the drive unit to prevent it from being started up unintentionally.
Attach a warning notice to the start switch!
The periods indicated in table 15 largely depend on the conditions under which the
gear unit is operated. Only average periods can therefore be stated here. These refer
to:
The operator must ensure that the intervals stated in table 15 are adhered to.
This also applies if the maintenance work is included in the operator's internal
maintenance schedules.
Table 15: Maintenance and repair work
Measures
Check the oil temperature
Check for unusual gear-unit noise
Check the oil level
Comparison of vibration values for
bearing monitoring with initial
values (reference values) on
starting up
Check gear unit for leaks
Check water content of oil
Perform the first oil change
Perform subsequent oil changes
Clean air filter
Clean fan and gear unit
Refill the Taconite seals with
grease
a daily operating time of
a duty factor "ED" of
an input­drive speed of
an operating temperature of
Daily
Daily
Monthly
Every 3000 operating hours
Monthly
After approx. 400 operating hours,
at least once per year
Approx. 400 operating hours
after start-up
Every 18 months
or 5000 operating hours
Every 3 months
Depending on requirements,
at least every 2 years
Every 3000 operating hours
or at least every 6 months
BA 5230 en 04/2011
59 / 67
24 h
100 %
1500 1/min
90 °C (applies to mineral oil)
Periods
See item 7.2.8.
See item 10.2.1.
See item 10.2.2.
See item 10.2.2.
See item 10.2.3.
See item 10.2.4.
See item 10.2.5.
Remarks