Oneil microFlash2 Programming Reference Manual page 30

Form Feed Active {CF:n}
{ A left bracket begins the command set.
CF:n n= y or Y: Act on form feed.
n = n or N: Ignore from feed (default)
Note: The form feed character (12
decimal or 0C Hex) can be configured to
be ignored.
} A right bracket ends the command set.
Configure Charger Beep {CG:n}
{ A left bracket begins the command set.
CG:n The printer can be configured to beep
when first connected.
N = y or Y: Beep
N = n or N: Do not beep (default)
} A right bracket ends the command set.
Configure RS-232 Handshaking {CH:n}
{ A left bracket begins the command set.
CH:n n = N : No handshaking
n = H : Hardware handshaking
n = S : Software handshaking
n = B : Both H/W and S/W (default)
} A right bracket ends the command set.
Job Status Reporting in Easy Print Mode{CJ:n}
{ A left bracket begins the command set.
CJ:n n = y or Y : Job Status Report ON
n = n or N : Job Status Report OFF (def)
Note: The Job Status report issues a
message via whatever communications
medium was used to send the job can
show successful job completion or if
there was a problem such as paper out.
} A right bracket ends the command set.
Chapter 3: Using Easy Print Mode
O'Neil Programming Language Reference Manual
Original Radio Ready
MF2, MF3, 2t, 4t 2t, 3l, 4t
X
Always On
Original Radio Ready
MF2, MF3, 2t, 4t 2t, 3l, 4t
X
Original Radio Ready
MF2, MF3, 2t, 4t 2t, 3l, 4t
X
Original Radio Ready
MF2, MF3, 2t, 4t 2t, 3l, 4t
X
X
X
X
X
29