Oneil microFlash2 Programming Reference Manual page 10

ESC Hn Multiplies the height n times
ESC Q n1n2 Advances n1n2 from the Q mark. For more
information about the Q mark, refer to Specifications
in the O'Neil Thermal Programming Guide.
ESC R n International font selection
ESC ! n Sets double wide and double high
ESC EZ Goes to Easy Print Mode
Note: Line Printer commands are case-sensitive. Make sure you use the correct
case when entering commands. An n indicates binary numbers, not ASCII
characters. For more information, see the individual command(s).
Esc C n Set Form Length
Format ESC C n
Dec 27 67
Hex 1B 43
Function Sets the page length in character lines. In the command
format, n represents the number of lines in the form and n is
a single byte. The default for n is 20 decimal, 14
hexadecimal. The range for n is 1-255.
Esc A n Set Interline Spacing
Format ESC A n
Dec 27 65
Hex 1B 41
Function Sets the number of blank dotlines that are fed between
character lines. The printer adds n (eight-bit binary number)
blank lines after completing the current line(s) and before
printing the next line.
The default value for n is zero where n equals the number of
inter-character blank dotlines in a single character. The range
for n is 1-155.
CAN Cancel Line Buffer
Format CAN
Dec 24
Hex 18
Function Cancels the character received on the currently forming, but
not yet printed, line.
Chapter 2: Using Line Printer Mode
n
n
n
n
O'Neil Programming Language Reference Manual
13
13
13
13
14
9