MAIN BOARD POWER CABLE CAN J BY J LCD CABLE QCPASS1415 HPOWER0225 HARETC0288 HLCDCA0017 RGB CABLE AV CABLE MULTI CABLE IR CABLE HARETC0240 HIRCAB0002 HRGBCA0013 HAVCAB0056 BUTTON CABLE REMOTE CONTROL HARETC0001 REMOTE0001...
ON: DOWN / OFF: UP * Please make sure to disconnect the power cable of interface and reconnect to apply dip switch setting whenever changing DIP switch. FUNCTION Dip S/W SELECT OFF : RGB MODE ON : RGB MODE SKIP OFF : HDMI MODE HDMI ON : HDMI MODE SKIP...
Page 5
FUNCTION POWER & PIP MENU Activating OSD menu Making a selection, changing image display ▲ Moving upward ▼ Moving downward Moving leftward ◀ (If you press this button 2 seconds long, you can access the factory mode) Moving rightward ▶ (If you press this button 2 seconds long, you can reset all the data about user environment)
Page 6
Menu of FACTORY IMAGE IMAGE H-POSITION PARK V-POSITION H-POSITION/V-POSITION Setting UTIL1 UTIL2 INFO MENU to Return SEL to Select/Save Menu of FACTORY IMAGE PAS TYPE PARK PAS SETUP UTIL1 REAR TYPE UTIL2 RADAR ENABLE INFO MENU to Return SEL to Select/Save PARK PAS TYPE: Select parking line type NOT USED: Do not use parking line...
Page 7
UTIL1 Menu of FACTORY NAVI/HDMI MODEL: Android, car-play, navigation IMAGE NAVI MODEL PARK AVOUT SELECT model setting UTIL1 FCAM TIME UTIL2 FACTORY RESET AVOUT SELECT: INFO Select background sound through car AUX MENU to Return SEL to Select/Save F-CAM TIME : Time setting for the front camera display (OFF, 3s, 5s, 10s, 15s) FACTORY RESET: Factory mode reset (YES/NO)
Page 8
Command Monitor OEM LCD cable Supplied LCD cable RGB Pin#7 is OEM HU UART-TX for connector UART Touch AV in *2 Rear camera in *1 Front camera in *1 Aux out *1 Video out *2 Android Supplied Navigation Power/CAN J by J CARPLAY OEM Cable 1.
Page 9
* Press high lighted OEM button for 3 seconds long to mode switch...
Page 10
* Press high lighted OEM button for 3 seconds long to mode switch MACAN...
Page 11
Q. I cannot change mode A. Check connection of Ground cable and IR Cable. Check LED lamp is on, if not check connection of POWER cable. Q. All I got on the screen is black. A. Check second LED lamp of the interface is on, if not, check A/V sources connected are working well.