Decompression Information - Uwatec ALADIN PRO ULTRA Operating Manual

4 Functions during the Dive

4.7 Decompression information

No-stop time is displayed if no decompression stops are necessary. The arrow <NO STOP> is visible if no
decompression stops are necessary. The figures indicate no-stop time in minutes.
depth dive time
CNS O LIMIT
2
O % MIX % MIX
2 2
DECOSTOP
NO STOP
max. depth deco info
4 sec
depth dive time
CNS O LIMIT
2
%
O % MIX
2
DECOSTOP
NO STOP
max. depth deco info
Decompression values
depth dive time
CNS O LIMIT
2
%
O % MIX
2
ft
DECOSTOP DECOSTOP
max. depth deco info
46
• No-stop display <99:> means remaining time of 99 minutes or
more.
• No-stop time is calculated assuming normal workload and current
water temperature.
WARNING
Messages: There is an acoustic alarm if no-stop time is less than 1 minute. In
this last minute, the no-stop display shows the flashing value <0>.
Response: In order to prevent a decompression dive, you must ascend a
few feet after this message.
It is dangerous and an unsafe diving practice to "push" the
Aladin Pro Ultra or any other decompression tool to its limits.
®
Avoid no-stop times of less than three minutes at any given
depth.
On entering the decompression phase, the arrow <NO STOP> disappears. The
arrow <DECOSTOP> appears. Right beside the arrow, the deepest decompression
stage in feet is displayed. Beside the decompression depth, the decompression
time of the displayed stage in minutes appears. The display <10ft 5:> means that
a decompression stop of 5 minutes at a depth of 10 ft has to be made.
When a decompression stop has been finished, the next higher decompression
stop is displayed. When all decompression stops have been made, the arrow
<DECOSTOP> extinguishes and the arrow <NO STOP> reappears. The indication
of time on the lower right shows the no-stop time again.
III Uwatec Aladin Pro Ultra
® ®