Important Notes - C-TEC AlarmSense CFP702-2 Installation & Maintenance Manual

LPCB APPROVED CFP ALARMSENSE 2/4/8 ZONE FIRE ALARM PANEL

IMPORTANT NOTES

THIS EQUIPMENT MUST BE INSTALLED AND MAINTAINED BY A SUITABLY SKILLED AND
TECHNICALLY COMPETENT PERSON. THIS EQUIPMENT IS A PIECE OF CLASS 1 PERMANENTLY
CONNECTED EQUIPMENT AND MUST BE EARTHED.
Items supplied with this panel
•
Installation & Maintenance Manual (i.e. this manual).
Explains how to install, commission and maintain the fire alarm control panel.
This manual MUST NOT be left accessible to the user.
•
User Manual / Log Book.
Gives detailed operational information, some of which will need to be referenced by the
installation engineer when setting up the panel. Sections of the user manual must be completed
by the engineer before system handover.
•
Torx key, for unfastening / securing the panel lid.
•
Electrical accessory pack, containing the following items:
8 x 0.47μF 50V capacitors
4 x 6K8 0.25W resistors
1 x Mains fuse
1 x battery connection kit
2 x nylon cable ties (for securing the batteries into the panel enclosure)
1 x LPCB approval label (see EN54 Compliance Statement, page 3 for details).
System design
Fire alarm system design is beyond the scope of this document. A basic understanding of fire alarm system
components and their use is assumed.
We strongly recommend that a suitably qualified and competent person is consulted in connection with the
design of the fire alarm system and that the system is commissioned and serviced in accordance with the laid
down specification and national standards. The fire officer concerned with the property should be contacted
at an early stage in case he/she has any special requirements.
We recommend you read BS 5839 Part 1: Fire detection and fire alarm systems for buildings - code of
practice for system design, installation, commissioning and maintenance, available at your local reference
library or from the BSI. Other national standards of installation should be referenced and adhered to where
applicable.
Equipment guarantee
This equipment is not guaranteed unless the complete system is installed and commissioned in accordance
with the laid down national standards by an approved and competent person or organisation.
This product has been manufactured in conformance with the requirements of all
applicable EU Council Directives.
INSTALLATION & MAINTENANCE MANUAL • Approved Document No. DFU7002020 Rev 4 • Page 4 of 24