Brother DCP-8085DN User Manual page 83

Error Message
Fuser Error
Jam Duplex
Jam Rear
Jam Inside
Jam MP Tray
Jam Tray 1
Jam Tray 2
No Paper
No Toner
No Tray
Out of Memory
Print Unable XX
Protected Device
76
Cause
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
The paper is jammed in the
duplex tray.
The paper is jammed in the back
of the machine.
The paper is jammed inside the
machine.
The paper is jammed in the MP
tray of the machine.
The paper is jammed in the paper
tray of the machine.
The machine is out of paper or
paper is not correctly loaded in
the paper tray.
The toner cartridge or the drum
unit and toner cartridge assembly
is not installed correctly.
The paper tray is not completely
closed.
The machine's memory is full.
The machine has a mechanical
problem.
The protect switch of the USB
Flash memory drive is on.
Action
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave the
machine for 15 minutes with the power on.
(See Paper jams on page 80.)
(See Paper jams on page 80.)
(See Paper jams on page 80.)
(See Paper jams on page 80.)
(See Paper jams on page 80.)
Do one of the following:
Refill the paper in the paper tray or MP
tray.
Remove the paper and load it again.
Re-install the toner cartridge or the drum unit
and toner cartridge assembly.
Close the paper tray properly.
Copy operation in progress
Do one of the following:
Press Start to copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See
Out of memory message on page 39.)
Print operation in process
Reduce print resolution. (See Advanced tab
in the Software User's Guide on the CD-
ROM.)
Disconnect the machine from the power for
several minutes, then reconnect it.
Turn off the protect switch of the USB Flash
memory drive.