Table of Contents
Advertisement
Operation
Flame Speed
Heat
Heat Disable
Temperature
Increase
Temperature
Decrease
Temperature
Display
(°C ↔ °F)
Brightness
Ambient Light
Sensor
Timer
Moods
Custom Color
Press
repeatedly to cycle through the 5 flame speeds.
Press
to turn the heat on or off. The fireplace will beep once and the
remain on the display when activated.
The fireplace can be operated in heat only mode by turning off the flame and color
effects.
Press and hold the
and the
the heat function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the
display.
Press
to decrease the temperature setting.
Press
to increase the temperature setting.
The temperature can be set from 7 °C to 30 °C (45 °F to 86 °F).
When the temperature setting is adjusted, the set temperature will flash for 2 seconds,
then the ambient room temperature will be displayed briefly.
Press and hold the
and the
performed on the hidden touch controls.
Press
repeatedly to cycle through the brightness and flicker modes.
Solid L - Low Brightness
Solid H - High Brightness
Cycle L - Low Brightness with flickering media bed lights
Cycle H - High Brightness with flickering media bed lights
Press
to turn the ambient light sensor on or off.
The ambient light sensor will automatically adjust the brightness of the fireplace lights
based on the ambient light in the room.
Press
repeatedly until the desired number of hours of the timer is displayed. When
this function is active, the fireplace will turn off after a set amount of time. The timer
can be set from 30 minutes (display will show .5) to 8 hours in intervals of 30 minutes.
To turn the timer off, press
While the timer is active, press the timer button to see the time remaining.
Press
repeatedly to cycle through the 8 different Moods, which will change the
colour of the media bed lighting.
1 - White
2 - Blue
3 - Violet
4 - Red
5 - Green
6 - Prism — media cycles through colors
7 - Prism — media cycles through colors at a faster speed
8 - Midnight mode — media bed lighting is off
Freeze the media bed lights to a custom color.
When in one of the Prism modes (see Moods), press
displayed to freeze the cycle on that color.
Press
again to resume the color cycle.
at the same time for 3 seconds to disable or enable
,
, or
at the same time for 3 seconds. This action must be
repeatedly until 0 appears on the display.
icon will
is pressed, --- will appear on the
while the desired color is
17
Advertisement
Table of Contents
