Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent person- al injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7213450100R08...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. W ARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of ire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for purchasing an electric ireplace from Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at www.dimplex.com/register Model and Serial Number Label Please carefully read and save these instructions.
This plug will it in a polarized aged in any manner, contact Dimplex outlet only one way. If the plug does Technical Service at 1-888-346-7539. not it fully in the outlet, reverse the plug.
IMPORTANT INSTRUCTIONS ⑮ Always plug heaters directly WARNING: Remote control into a wall outlet/receptacle. contains a small battery. Keep away Never use with an extension cord from children. If swallowed, seek or relocatable power tap (outlet/ medical attention immediately. power strip). WARNING: Do not install battery ⑯...
Figure 1. Make sure that the product is connected to an outlet having the same con- iguration as the plug. No adapter should be used with this product. Clearance for air CAUTION: www.dimplex.com...
Page 7
10.0in. IMPORTANT: If not using a PF3033 (816mm) (579mm) (254mm) Dimplex mantel, the ireplace NOTE: The ireplace needs to be must be installed in an enclosure (226 cm ) of installed to ensure 35 in with the following minimum inter- intake air, into the back of the unit, on nal/opening dimensions - Figure 2.
Front glass watertight and must be installed as to prevent water from entering the unit. This unit must be installed away from showers, tubs, etc. Never locate ire- place where it may fall into a bathtub or other water containers. www.dimplex.com...
Fireplace Installation Wiring Diagram MAIN BOARD LOGSET JUNCTION BOARD POWER SUPPLY THERMAL CUT OUT MEDIA LED LIGHT ASSEMBLY RELAY BOARD HEATER ASSEMBLY FLAME BED LED ASSEMBLY (RGB) TOP LIGHT ASSY TOP LIGHT ASSY GESTURE ASSY FLICKER MOTOR FLAME LED LIGHT ASSEMBLY (1W)
Standby: Turns unit On or Off. mately 4 in. (102 mm) in-front of the → Activated by pressing the cor- gWave sensor in the upper right hand responding button on the remote corner of the unit, the unit and different www.dimplex.com...
Page 11
Operation ① Figure 4 ③ gWave ② Controls LED Pilot Light ⑤ ④ Gesture On/Off ⑥ ⑦ ⑦ ⑥ ⑩ ③ ⑧ ⑨ ⑩ ⑪ or “waving” in-front of the gWa- . "Waving" up will turn the unit On and "Waving" down will turn the unit Off.
Page 12
, then pressing , will toggle lighting, lame base and media between °C and °F. lighting (if applicable). Eco: Runs the heater in a NOTE: The last option is a per- reduced wattage range when sonalized colour setting ("P"), where www.dimplex.com...
Page 13
Operation using the buttons on the remote the → Activated and adjusted by re- lighting of the unit can be adjusted peatedly pressing the correspond- to any shade of any colour. The ing button on the remote. initial setting is no light (R=0, B=0, •...
Page 14
During this pro- cess you will hear repeated beeps and the display may turn on and off. CAUTION: If you need to continu- ously reset the heater, disconnect power and call Dimplex customer service at 1-888-DIMPLEX (1-888-346-7539). Battery Replacement (Figure 4)
Maintenance scratching, do not use abrasive WARNING: Disconnect power cleaners or spray liquids on the glass before attempting any maintenance surface. or cleaning to reduce the risk of ire, electric shock or damage to persons. Fireplace Surface Cleaning To remove ingerprints or other CAUTION: Allow adequate time for the element and body casing to marks, the exterior inish can be...
Limited warranty service requires a defect the purchaser assumes the entire proof of purchase of the product. cost of all necessary servicing or repair. What Dimplex will do in the event of a What this limited warranty covers and for defect? how long...
Page 17
Warranty product or part without charge. If NO EVENT WILL DIMPLEX, OR ITS Dimplex is unable to repair or replace OFFICERS, DIRECTORS, OR AGENTS such product or part, or if repair or BE LIABLE FOR ANY DIRECT LOSSES, replacement is not commercially...
Need help?
Do you have a question about the PF2325 and is the answer not in the manual?
Questions and answers