Table 3-3. Mib Ii Standard Trap Descriptions; Table 3-4. Network Test Trap Descriptions - ADTRAN T3SU 300 User Manual

Trap Type
Cold Start
Link Up
Link Down
Auth. Failure
Trap Type
Network Test In when the unit goes into a DS3 network test, either
Network Test
Out
61200217L1-1
Trap Type If ENABLED, this trap is sent...
Idle Signal when the unit receives indication from the far
end unit through the FEAC channel that the far
end unit is receiving an idle signal (1100) over
the entire DS3 payload.
Eqpt. Fail when the unit receives indication from the net-
NSA work through the FEAC channel of a non-ser-
vice-affecting failure in the network equipment.
Eqpt. Fail SA when the unit receives indication from the net-
work through the FEAC channel of a service-af-
fecting failure in the network equipment.
Com. Eqpt. when the unit receives indication from the net-
Fail NSA work through the FEAC channel of a non-ser-
vice-affecting failure in the network common
equipment.

Table 3-3. MIB II Standard Trap Descriptions

If ENABLED, this trap is sent...
when the unit is first powered on.
when the network recovers from a Link Down con-
dition and data transmission is restored.
when a network condition prevents data transmis-
sion. This could be either an alarm or a network
test.
when an SNMP request is made with the wrong
read or write community names.

Table 3-4. Network Test Trap Descriptions

If ENABLED, this trap is sent...
commanded locally or remotely.
when the unit is in a DS3 network test and the test
is terminated.
T3SU 300 User Manual
Chapter 3. Configuration
3-17