Cleaning & Maintenance - NuWave Bravo XL Owner's Manual

INSTRUCTIONS
Carryover Cooking:
1. During cooking, it
will display current
probe temperature,
while it displays probe
temperature, "PRB" is lit.
2. During cooking, press
TEMP/TIME. Press
TEMP/TIME again and
the chosen temperature
of the oven (default
350F/177C) will display.
While it displays the
cooking temperature,
"PRB" is no longer lit.
3. Press and hold PROBE
button for 1second.
Adjust desired probe
temperature by using
the START/PAUSE dial.
4. When the unit reaches
10F (-12C) under the
target Probe temperature,
the unit will alert with 3
sets of short beep sounds.
• This will happen every
time the probe is in use.
• If desired cooking time
is finished but desired
probe temperature is not
achieved yet, the unit
will continue cooking
until probe temperature
is achieved.
30 30
instructions
Example:
Probe: 200F (93C)
Regular Cooking: 380F
(193C), 5 min.
Sear 2: 400F (204C), 2 min.
Warm: 140F (60C), 30 min.
5. If probe temperature
was not achieved under
regular cooking 380F
(193C), 5 min., the unit
shall continue to cook at
380F (193C) until probe
temperature is reached
and then go to Sear 2
and then to warm.
CLEANING & MAINTENANCE
Before First Use:
Wash all removable parts in
1
warm, soapy water or in the
dishwasher, top rack only.
1. Remove all the packaging
materials.
2. Remove the glue and
labels on the appliance.
3. Clean the Cooking Racks,
Baking Pan, Broiler Rack,
Stainless Steel Mesh
Rack and Crumb Tray
thoroughly with hot water,
a nonabrasive sponge,
and mild dish detergent,
or in the dishwasher, top
rack only.
4. Rinse the Pizza Stone with
hot water before use. Allow
the Stone to dry at least
30 minutes then place in
a very hot oven for 30-45
minutes. Turn off oven
and allow the Pizza Stone
to completely cool before
touching.
5. Wipe the insides and
outside of the Bravo with a
damp dishcloth or wet cloth
and dry thoroughly.
IMPORTANT - Do not immerse
unit in water or attempt to
cycle through dishwasher.
The outer surface may be
cleaned by wiping carefully
with a damp dishcloth or
sponge. Make sure unit has
cooled completely prior to
cleaning.
Clean After Each Use:
1. Allow the Bravo to cool
completely before cleaning.
2. Always unplug the Bravo
from the electrical outlet.
NEVER clean the unit while
it is plugged in.
3. Never use harsh abrasive
or corrosive product
cleaners, as they may
damage the finish or oven
surface. Wipe the exterior
with a clean, damp cloth
and dry thoroughly.
4. Apply the cleaning agent
directly to a cloth towel, not
directly to the unit, before
cleaning.
5. To clean interior, use a
damp cloth, mild liquid
soap solution, and a clean
cloth towel.
6. Never use steel wool pads,
etc., on interior or exterior
of the Bravo.
7. NEVER HANDLE A HOT
PIZZA STONE. Allow the
Pizza Stone to completely
cool before cleaning.
Once cooled, wipe the
Stone with a clean damp
towel then rinse in a sink
with cool water and dry
completely. WARNING:
NEVER submerge or rinse
a hot Pizza Stone in water.
The hot Stone may crack
and break underwater,
causing injury.
8. When the glass window
is completely cool, spray
glass cleaner on a clean
cloth towel. Clean both
inside and outside of
window. Use a damp cloth
to rinse the window then
dry completely with a clean
dry towel.
31 31
nuwavenow.com nuwavenow.com